two cylinders not working when idle

YEMYEM42 · Post by **YEMYEM42** » Wed Jul 02, 2008 3:46 pm

I have a civic EK with a swap K24/K20 with ITB, skunk2 cams stage 2, CP high compresion pistons and R/C 550CC inyectors

After I load the base calibration and start the engine the red light on the ECU still on, didn?t datalog and 2 cylinders where not working on idle.

then I used a friend?s Hondata ECU same as mine, load the base calibration and everything work perfect and the light on the ECU stay green

I call the person that sold me the ECU and the just told me the problem is on the calibration or a protection activated.

anybody have any clue? :roll: thank you very much

YEMYEM42 · Post by **YEMYEM42** » Thu Jul 03, 2008 11:54 am

no help?

another thing my friend ECU have and older firmware than mine

Post by **Spunkster** » Thu Jul 03, 2008 11:55 am

If you go to online, tools and clear security, close the program, reopen it and go to file, new and laod a new calibration into the ecu and the problem persists, I would recommend getting your money back from the person that sold you the ecu.