Hondata 4 Bar Map Sensor

Tchleung · Post by **Tchleung** » Sat Jun 21, 2008 10:23 pm

Well I got my Hondata/Omnipower 4 bar map sensor. First thing I did was pressurize it to 30psi holding the sensor in my hand. helf fine there but 35 psi blew the cases apart. it's not a big deal tho, looks like cheap permatex clear silicone holding the halves together, but again, this is me testing it in my hand, not botled down holding it together. so I jsut JB welded the cases togetehr inside and bolted it down. No problems :)

Post by **Spunkster** » Mon Jun 23, 2008 1:19 pm

The map sensor is designed to be bolted to the manifold. When installed correclty they have been tested to 120psi without failing.