loud beeping noise when starting datalog

V-Spec race development · Sun Jun 08, 2008 10:31 pm

Has anyone have this problem? I never heard this beeping noise before til now. Every time i start to datalog, the beeping start and it get annoying. Please let me know how I can turn that off besides turning the volume down or muting it. Thanks in advance.

Post by **Spunkster** » Mon Jun 09, 2008 10:50 am

Change the setting of your display. You have set a warning for something.

V-Spec race development · Mon Jun 09, 2008 11:58 pm

spunkster, how can I change my setting on the display? Sorry for asking. I downloaded this display from one of the member from display template forum. thank you sir.

Post by **Spunkster** » Tue Jun 10, 2008 9:36 am

Are you sure you have not downloaded a Kmanager display?

V-Spec race development · Tue Jun 10, 2008 9:43 am

I'm sure I downloaded the Smanager template. If you look at the top left corner of the display screen it says "Hondata Smanager 1.3.6.0- display" Thank you for looking this up for me Spunkster.

Post by **Spunkster** » Tue Jun 10, 2008 11:24 am

SManager will always say SManater at the top. IT is possible that you downloaded a display that was created for KManager though and have loaded that into SManager by mistake. Try downloading a different display and see if it works better for you.

V-Spec race development · Wed Jun 11, 2008 12:21 am

ok i will do that. I"m going to load the one you loaded title " amber full cluster display" and see if that works. I'll let you know. thanks again.

V-Spec race development · Thu Jun 12, 2008 7:13 pm

I uploaded the display above and it works. No more beeping while datalogging. Thank you Spunkster.