Lean Protection question.

[Teamko]

I would like to use the lean protection setting. I have approximately 15+lbs supercharged k24a2 that I am street tuning.

I have just installed a 4 bar. The 2.5 bar didn't hack it.

my current settings are
max lam 13:1
engine load 8
trigger time 250ms

I am thinking that I should have a much longer trigger time since its in ms.

I don't have the second one set.... any suggestions?

[magnEsium]

with boost you actually want a low trigger time and a low load for it to cut


try 13:0

over 4 PSI

150ms

[Teamko]

Thanks