what wide band should i use AEM or PLX??

671k20a · Post by **671k20a** » Mon May 19, 2008 10:56 pm

WHATS UP! i NEED SOME HELP... I have a 2000 SI W/ a k20aR. I'm not getting any reading of air fuel ratio thats on the kpro. So i plan to buy a wide band, but not sure what to get. Thanks alot in advance.

Post by **Spunkster** » Tue May 20, 2008 9:45 am

What is the code on the side of your ecu?

671k20a · Post by **671k20a** » Tue May 20, 2008 10:59 am

671k20a · Post by **671k20a** » Wed May 21, 2008 9:27 pm

guess nobody wants to help.. thanks anyways...

Post by **Spunkster** » Thu May 22, 2008 9:23 am

I would recommend the PLX. This will allow you to use the narrowband output from the PLX for running the car in closed loop and the wideband to datalog.

671k20a · Post by **671k20a** » Sat May 24, 2008 5:06 pm

Spunkster wrote:I would recommend the PLX. This will allow you to use the narrowband output from the PLX for running the car in closed loop and the wideband to datalog.

which plx 100 or 200? And thanks alot for your help.

Hondata

what wide band should i use AEM or PLX??

what wide band should i use AEM or PLX??

Thanks...