Hondata boost control

rudebwoy · Post by **rudebwoy** » Tue May 06, 2008 2:42 pm

I am contemplating on using the boost control, I so happens to have all parts needed to do this conversion PWM components , boost solenoid etc. I currently have a greddy profec b with a brand new solenoid, I plan to use the greddy solenoid, I've seen it done before,but it if fails I also have a MAC solenoid but since the greddy is already installed I will use it. anyways I've researched everything but haven't found anything on HI/LO boost selection, I hope to use my profec remote switching system as my hi/lo boost switch.
I have an idea but just want to be sure.
so to install I assume one wire of the remote transmitter will go to ground, and the other will connect to pin B5 for example?

Post by **Spunkster** » Tue May 06, 2008 4:42 pm

Since I'm not familiar with how the Greddy controller works, I cannot say how it should be connected or work.

rudebwoy · Post by **rudebwoy** » Wed May 07, 2008 3:17 am

well in general how would it be connected with the hondata boost solenoid?
the greddy have 2 wires just like the MAC. and I saw someoone used it before.

Post by **Spunkster** » Wed May 07, 2008 10:26 am

In Smanager, go to Help, Contents, and search for "boost control solenoid installation"

rudebwoy · Post by **rudebwoy** » Wed May 07, 2008 2:34 pm

I'read all this but it still havent answer in specific what I am trying to find out.

I wanna use an external switch to switch between high and low boost levels.
should intall one lead of the switch to ground and one lead to pin b5?

Post by **Spunkster** » Wed May 07, 2008 3:09 pm

rudebwoy · Post by **rudebwoy** » Fri May 09, 2008 8:47 pm

thank you sir