1.3.5.0 Lamda conversion table?

[dpenterprise]

Has anyone had any problems with volt/lamda conversion table? I try to put numbers in but other numbers pop up that are not even close. I have a plx and can't seem to get it to work with this version. Any help would be much appreciated.

[dpenterprise]

Ok I was able to get the voltage/lambda conversion table to read like this:

Voltage 0.00 5.00 5.00
Air fuel 10.00 20.00 20.00

But what I had to type in for it to read like that was:

Voltage 0.00 5.00 5.00
Air fuel 21.61 10.805 10.805

Why does it do this? I also wanted to know why there are 3 voltage columns if the last 2 are the same?

[Spunkster]

we are looking into this

[Too_smooth]

Any new findings about this problem?

I don't know if this is going to work or not but I entered these values to get the values I wanted.

Voltage: 0.00 5.00 5.00
A/F : 21.6 40.21 40.21

21.6 made 10.0 show up in the A/F box.
40.21 made 19.99 show up in the A/F box.

Hope this made sense and like I said I haven't tried it yet.

[Hondata]

Fixed with 1.3.5 If you're still getting the problem, try re-downloading it.

[holset hatch]

version 1.3.6 is not letting me input any #'s into those boxes, they just revert back to initial settings after i input my #'s. even on a loaded tune they revert the #'s back :x

[Too_smooth]

I'll try downloading it again.

[ek_hatch]

version 1.3.6 is not letting me input any #'s into those boxes, they just revert back to initial settings after i input my #'s. even on a loaded tune they revert the #'s back :x

im getting this same problem with 1.3.6

[ek_hatch]

never mind fixed my problem. was in lamda not a/f