No VSS on 2006 RSX-S

john_civic · Post by **john_civic** » Mon Apr 28, 2008 3:00 pm

Hi..

I baught a 02-04 Kpro and I sent it to Hondata to modified for a 05-06 RSX. I installed the harness and Kpro.

Everything is working except my speedo.

I selected countershaft diven speed sensor.

On my laptop the speedo is working pretty good but their is no signal to the cluster...

When I use my OEM 2006 ECU, my speedo is working.

So I check for the conversion harness. E26 (blu/wht wire) is the VSSOUT. On the harness this wire goes to B11 in the PRB KPRO'ed ECU. B11 is normaly non used on 02-04 PRB.

I tried many times to reupload my Kpro, but nothing.

Post by **Spunkster** » Mon Apr 28, 2008 4:17 pm

What vehicle is this in?

Garrett_si · Post by **Garrett_si** » Mon Apr 28, 2008 4:25 pm

Civic Eg 92-95

john_civic · Post by **john_civic** » Tue Apr 29, 2008 9:24 am

Garrett_si wrote:Civic Eg 92-95

Right... and I tried on my friend 05 rsx-s. Same problem, no speedo.

Garrett_si · Post by **Garrett_si** » Tue Apr 29, 2008 1:46 pm

I suspect a K-pro low frequency output problem....

someone to confirm it?

Post by **Spunkster** » Tue Apr 29, 2008 3:09 pm

This is not designed for engine swaps. There is no wiring from the ecu to the speedometer in an eg. Check the output on B11 to see if you get 4 pulses per wheel revolution

john_civic · Post by **john_civic** » Tue Apr 29, 2008 9:03 pm

Spunkster wrote:This is not designed for engine swaps. There is no wiring from the ecu to the speedometer in an eg. Check the output on B11 to see if you get 4 pulses per wheel revolution

I will check for B11, but it's supposed to work in my friend's 2005 RSX-S(100% stock)