S2000 Kpro Fitment

JustinC · Post by **JustinC** » Mon Mar 24, 2008 11:12 am

Was wondering how the fitment was on the S2K. I can't seem to get both holes to line up. I can get it in the mount..place the rubber thing in and then can only bolt in the hole closes to the door...the other one is about a half inch off.

Any tips...also do you leave the USB cable installed ?

Post by **Spunkster** » Mon Mar 24, 2008 11:54 am

It should fit perfectly. The USB cable should be left in since it will be nearly impossble to plug it in after the fact.

From the Hondata website:

JustinC · Post by **JustinC** » Mon Mar 24, 2008 12:14 pm

Spunkster wrote:It should fit perfectly. The USB cable should be left in since it will be nearly impossble to plug it in after the fact.

Okay, well I will take the bracket off the ecu and then test fit it, b/c it doesn't fit perfectly for me. Maybe there is something in the way...I can't see.

JustinC · Post by **JustinC** » Mon Mar 24, 2008 8:50 pm

I finally got it to bolt up, but it took me an hour of shoving it against the rubber mount to get it to sit properly, I think maybe that bracket is a little tight against the rubber piece.

JustinC · Post by **JustinC** » Mon Mar 24, 2008 8:50 pm

I finally got it to bolt up, but it took me an hour of shoving it against the rubber mount to get it to sit properly, I think maybe that bracket is a little tight against the rubber piece.