Secondary map never activates.

Too_smooth · Post by **Too_smooth** » Thu Mar 20, 2008 1:59 pm

In the past when I activated the switch I would see the map switch in SManager. Seems to me that this stopped working for me when I upgraded to 1.3.3. The system sees the switch when I switch it on and off. I also have changed the switch to use one of the other switches that I use for data logging and launch control. Those work fine regardless of which switch I set to activate them.

I'll upload the map just in case.

Post by **Spunkster** » Fri Mar 21, 2008 6:14 pm

Change the minimum engine speed to 200rpm

change your engine load to something sensible like 70KPA and 500KPA

and then set your throttle to somethign above 0 as well

The settings you have can never be met

Too_smooth · Post by **Too_smooth** » Fri Mar 21, 2008 6:50 pm

I'll try that...it's funny that it worked before though. I'll let you know if that works.

Too_smooth · Post by **Too_smooth** » Sun Mar 23, 2008 2:14 pm

Thanks...it works again.

I changed the mininum engine speed to 100 and engine load to -14.5. I left throttle at zero.

Basically I want the lowest values in there possible so the map would switch as soon as I hit the switch.