boost control issues

Lazysk8r2 · Post by **Lazysk8r2** » Mon Mar 17, 2008 4:29 pm

I have the GM boost solenoid 1 wire connected to the battery for the power and the other wire connected to A11 i think.

I have the Boost control enabled and normally open clicked and fixed duty cycle set to 0%. Its not hitting 7 pounds like in the wastegate spring. Its keeps on hitting boost cut set to 10. I am trying to get it to what the spring is set for. What am i doing wrong?

Post by **Spunkster** » Mon Mar 17, 2008 4:39 pm

What happens when you just disable boost control?

Lazysk8r2 · Post by **Lazysk8r2** » Mon Mar 17, 2008 5:01 pm

it goes past and spring pound and hits the boost cut set to 10. iv pulled the vac line off also and it went to 7 which is the spring

Post by **Spunkster** » Mon Mar 17, 2008 5:07 pm

A normally open solenoid cannot be disabled or set too low. Since it is normally open, activating the solenoid is actually closing the flow of air off..try setting it to 15% and then 25% and see what it does.

verlee24 · Post by **verlee24** » Wed Mar 26, 2008 2:43 pm

i have the same exact problem. boost cut set at 10, boost set for 7, spring is 7psi. but it always goes to boost cut. got any other ideas? i tried normally open at 25% 15% and 5%

Post by **Spunkster** » Wed Mar 26, 2008 2:59 pm

http://www.hondata.net/forum/viewtopic.php?t=3772