GM 3 BAR

BOOSTEDFERIO · Post by **BOOSTEDFERIO** » Fri Feb 22, 2008 3:52 pm

hi - sorry if this is a dumb question. i just installed a gm 3 bar instead of my stock map. i went under the option to change the type of map sensor. i chose custom a scrolled through and did not see the gm 3 bar as an option. am i missing something. is it listed as some other type of map? i would appreciate the help. thanks!

Post by **Spunkster** » Fri Feb 22, 2008 5:38 pm

IT may be similar to the Motec, but then again it may not be. THere are several different GM sensors so we do not recommend their use.

Tchleung · Post by **Tchleung** » Sat Feb 23, 2008 10:35 pm

what part# is your GM map?

Panta83 · Post by **Panta83** » Sun Feb 24, 2008 1:34 pm

I got the same prob

Here's the map

Panta83 · Post by **Panta83** » Mon Feb 25, 2008 1:42 pm

UP ?

Please ?

laziebun · Post by **laziebun** » Mon Feb 25, 2008 4:05 pm

You have to go unde the custom and figure out the Scalar and offset yourself..... so.... check this out i think this what you might be looking for http://hondata.net/forum/viewtopic.php? ... ght=#23621

let me know if this helps GL

ExViTermini · Post by **ExViTermini** » Wed Feb 27, 2008 6:49 pm

I've noticed a lot of people that are using the GM/MSD 3 bar map have the Motec 3 bar selected. There is an option in the newest release though that does have the GM 3 bar as a selection.

I personally am using the Motec 3 bar setting and it appears to work just fine...

Panta83 · Post by **Panta83** » Sun Mar 09, 2008 12:40 am

Same thing !

I run the Motec 3 bar right now and it works fine