KPro datalogging with the Race Technology DL1

[Hondata]

The KPro can be connected to the Race Technology DL1 for datalogging with the following notes:

- this is not suitable for a DC5 or EP3 as the dash will be partially disabled.
- only PRB calibrations work.
- the DL1 serial port must be configured to the same speed as the ECU output (either 9600 or 115200 bps).

For more information see the KManager help under 'Serial Output'.

For the Race Technology Analysis application to interpret datalogged values, a DLL must be installed in the 'OtherFiles' directory under the main Race Technology install directory. Note that currently we can only supply an interface DLL for a early version of the Race Technology software, but in the future this DLL will be supplied as part of the install from Race Technology.