Oil Pressure

poison · Post by **poison** » Sun Jan 27, 2008 1:11 pm

I'm surprised this hasn't been brought up before (at least I haven't seen)..

But is oil pressure able to be pulled/read in Kpro from the ECU?

It'd be nice if it was and monitored.

Thanks,

Post by **Hondata** » Mon Jan 28, 2008 10:07 am

There is not an engine oil pressure sensor.

trlaing · Post by **trlaing** » Tue Feb 12, 2008 2:30 am

I had to cough up for some nice Defi DIN gauges with a wee part that goes between the oil filter and engine with oil pressure and oil temp sensors on it. Simple to fit. I'm sure there will be cheaper alternatives to pop on the end of the sensor cables than the Defi article .

I think it is a very sensible addition to any VTEC as I have noticed that the oil takes a good 10 minutes to warm up - at least it does in Scotland. Most VTEC owners I know start driving hard as soon as the coolant gauge has moved to it's usual position.