TPS reading eratic

K-Series Programmable ECU installation questions / support issues
Locked
sharper
Posts: 14
Joined: Sun Dec 23, 2007 6:43 am

TPS reading eratic

Post by sharper »

Noticed on a recent datalog that my tps reading is fluctuating, reading down to 87% at wot, in spikes all over the place. Had to recently replace with an omni-power unit. Any ideas
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

Is your TPS sensor making contact with anything, like the hood?
sharper
Posts: 14
Joined: Sun Dec 23, 2007 6:43 am

Post by sharper »

Spunkster wrote:Is your TPS sensor making contact with anything, like the hood?
No its clear of everything. Datalogged a few runs today and on 4 out of 5 times the TPS only deviates 3-4%, and then on that 5th run it deviates to below 85%. Have attached a datalog to show.
Recently replaced with an Omni power uni?? Any way to check it.
You do not have the required permissions to view the files attached to this post.
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

It sounds like you have checked it and it had been damaged or is faulty. I would suggest contacting Omni Power. The only other posibility is that you have a wiring fault or a bad ground somewhere. Try the sensor in another vehicle.
sharper
Posts: 14
Joined: Sun Dec 23, 2007 6:43 am

Post by sharper »

New sensor is on its way, still under warranty, Kingmotorsports handled it no problem. Will update when new one is installed.
Locked