Im trying to find out how to wire in the new wideband sensor from PLX into my laptop/ecu with the Hondata S300. The online tips and instructions only show the old PLX M100. Anyone have any ideas or thoughts or even the steps to set this up, nudge nudge to Hondata Admin.
im not saying its not, instead of online having it say options settings then wideband setup to just go in through closed loop in parameters.
but i want to confirm that the setup is the same since its new. make sense?
perfect. thank you, and double thank you mike, my name as well, im using your display with a few thing changed for my setup, rev limit etc. its great, good work and thanks again for all the help.
Piling on to this post, looking at the instructions, everything looks pretty clear to install, but I have one question:
The 1k ohm resistor: I have an old O2 adapter - just solder a 1k ohm resistor across the black wires (after removing the old sensor, of course), correct?
The instructions on the website:
"The adapter plug does two things. It puts a 1K resistor across the two black wires..."
Seems to imply the adapter itself provides the 1k ohm resistance, which I'm 99% sure is not the case.
