Update Calibration Prompt

EMk20a2 · Post by **EMk20a2** » Wed Nov 14, 2007 7:45 pm

When I plug my laptop in to datalog I get a prompt to update my calibration. I am assuming that this means the calibration was created with a older version than I have on my laptop. I typically close the window and datalog because I don't know how to update the calibration. I was just wondering if this was bad to do, if it could screw up my calibration?

Post by **Hondata** » Thu Nov 15, 2007 9:02 am

Do you have the calibration saved on the laptop? If you do, just load it and upload it.

EMk20a2 · Post by **EMk20a2** » Thu Nov 15, 2007 5:21 pm

that is the thing I don't it is on the shop's that tuned my car, so now what do I do? Is it messing anything up with the car by not?

Post by **Hondata** » Fri Nov 16, 2007 9:16 am

Ask your tuner for the calibration. If you can't get it, then download from the ECU.