Lambda problem...

Stuart · Post by **Stuart** » Sat Nov 03, 2007 11:15 am

OK,

as the data output is not avaliable on PRA ECU's, I have changed it out for a PRD (all I could find in a hurry!).

re-wired the engine loom etc for the different primary lambda sensor, etc etc.

engine runs just fine, but the lambda display is perminently 0

now, before you say it's not wored right or it's faulty, it's working and is running closed loop just fine??

I have attached a datalog, it's from one of the std maps for an RSX

Thanks

Post by **Hondata** » Mon Nov 05, 2007 10:06 am

Looks ok to me. Make sure KManager is updated, then check in Settings that the wideband is set to the built in wideband.

Stuart · Post by **Stuart** » Mon Nov 05, 2007 3:43 pm

thanks!

it was in settings (set to ELD??)

looks like it got changed in an version update?

Stuart