Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Tue Aug 21, 2007 2:11 pm
Does anybody have a map for a b16 with 880 injectors? Just need a base map to compair mine with.
Phantomhatch
Posts: 35 Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh
Post
by Phantomhatch » Fri Sep 07, 2007 4:57 pm
This is my map very good Daily driving Afr's
The map is set very rich cause i was having fuel delivery problem and maxed my injectors.. this is JUST a driving tune
You do not have the required permissions to view the files attached to this post.
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Sat Sep 08, 2007 7:54 am
Thanks alot. Will try it out.
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Sat Sep 22, 2007 1:33 pm
Anybody else have a tune for 880's?
Phantomhatch
Posts: 35 Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh
Post
by Phantomhatch » Wed Oct 03, 2007 10:50 am
here is the retuned map
You do not have the required permissions to view the files attached to this post.
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Wed Oct 03, 2007 11:08 am
Thanks again....
Phantomhatch
Posts: 35 Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh
Post
by Phantomhatch » Wed Oct 03, 2007 12:04 pm
Specs on the map
Turbo: 60-1 starts to see + pressure around 3700 full pressure (17psi) at about 4500
Injectors: PTE 880cc
Timing: conservative
-Fuel : around 11.5-9 at full boost
--driving afr's 14.3-15.3 very nice ans load index set.
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Fri Oct 05, 2007 11:38 am
I am going to try it out tonight. I wish I made 17psi at 4500rpm, I dont make full boost till around 6000rpm with a SC61 on my B16a. Do you know what power it laid down?
Phantomhatch
Posts: 35 Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh
Post
by Phantomhatch » Fri Oct 05, 2007 1:57 pm
turborex wrote: I am going to try it out tonight. I wish I made 17psi at 4500rpm, I dont make full boost till around 6000rpm with a SC61 on my B16a. Do you know what power it laid down?
I need to correct the 45 its 550 i get 17psi . I am running a gar. 60-1 with a .63 hot side 76 trim.
This map will do you good. I do not know the power at this moment. Im guessing around 300-330 wheel
turborex
Posts: 7 Joined: Tue Sep 05, 2006 5:26 pm
Post
by turborex » Mon Oct 08, 2007 3:32 pm
It is a little rich at idle with my setup so i had to lean it out quite a bit.
What is your fuel pressure set at?
Phantomhatch
Posts: 35 Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh
Post
by Phantomhatch » Tue Oct 09, 2007 3:14 pm
turborex wrote: It is a little rich at idle with my setup so i had to lean it out quite a bit.
What is your fuel pressure set at?
45 psi at idle.