B16 with 880's

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

B16 with 880's

Post by turborex »

Does anybody have a map for a b16 with 880 injectors? Just need a base map to compair mine with.
Phantomhatch
Posts: 35
Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh

Post by Phantomhatch »

This is my map very good Daily driving Afr's

The map is set very rich cause i was having fuel delivery problem and maxed my injectors.. this is JUST a driving tune
You do not have the required permissions to view the files attached to this post.
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

Post by turborex »

Thanks alot. Will try it out.
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

Post by turborex »

Anybody else have a tune for 880's?
Phantomhatch
Posts: 35
Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh

Post by Phantomhatch »

here is the retuned map
You do not have the required permissions to view the files attached to this post.
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

Post by turborex »

Thanks again....
Phantomhatch
Posts: 35
Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh

Post by Phantomhatch »

Specs on the map

Turbo: 60-1 starts to see + pressure around 3700 full pressure (17psi) at about 4500

Injectors: PTE 880cc

Timing: conservative

-Fuel : around 11.5-9 at full boost

--driving afr's 14.3-15.3 very nice ans load index set.
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

Post by turborex »

I am going to try it out tonight. I wish I made 17psi at 4500rpm, I dont make full boost till around 6000rpm with a SC61 on my B16a. Do you know what power it laid down?
Phantomhatch
Posts: 35
Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh

Post by Phantomhatch »

turborex wrote:I am going to try it out tonight. I wish I made 17psi at 4500rpm, I dont make full boost till around 6000rpm with a SC61 on my B16a. Do you know what power it laid down?
I need to correct the 45 its 550 i get 17psi . I am running a gar. 60-1 with a .63 hot side 76 trim.

This map will do you good. I do not know the power at this moment. Im guessing around 300-330 wheel
turborex
Posts: 7
Joined: Tue Sep 05, 2006 5:26 pm

Post by turborex »

It is a little rich at idle with my setup so i had to lean it out quite a bit.
What is your fuel pressure set at?
Phantomhatch
Posts: 35
Joined: Thu Feb 01, 2007 9:05 pm
Location: lima, oh

Post by Phantomhatch »

turborex wrote:It is a little rich at idle with my setup so i had to lean it out quite a bit.
What is your fuel pressure set at?
45 psi at idle.
Locked