Which map sensor is recommended for about 35+ lbs of boost

thudreem · Post by **thudreem** » Wed Sep 19, 2007 8:25 am

I have the GM 3 bar currently at 26 lbs of boost but I want to increase the boost. Should I go with a motorola 4 bar, or a AEM 3.5 bar or 5 bar. I want to keep a boost cut that is why I need to change from the GM 3 bar.

What works best for the s300?
Thanks,

Sean

WickedCivicNY · Post by **WickedCivicNY** » Wed Sep 19, 2007 8:44 am

AEM 5 Bar

thudreem · Post by **thudreem** » Wed Sep 19, 2007 8:49 am

WickedCivicNY wrote:AEM 5 Bar

If I do not think I will go over 37lbs should I go with the 5 bar?

Also, how is the resolution on that sensor?

planetspeed · Post by **planetspeed** » Fri Sep 21, 2007 9:03 am

This is where "More is better" works..If you do plan to boost higher, a 5bar is the way to go..

boostedcivicsir · Post by **boostedcivicsir** » Sat Sep 22, 2007 8:19 pm

do it once and be done.

SFWD 1934 · Post by **SFWD 1934** » Sun Oct 07, 2007 1:35 am

boostedcivicsir wrote:do it once and be done.

I agree. Not to mention, you can alter all the load points to what you want. So you can have the 5 bar with PSI load points that go only to 35 PSI as opposed to 60 PSI.

Jason

thudreem · Post by **thudreem** » Fri Oct 12, 2007 10:05 am

SFWD 1934 wrote:
boostedcivicsir wrote:do it once and be done.
I agree. Not to mention, you can alter all the load points to what you want. So you can have the 5 bar with PSI load points that go only to 35 PSI as opposed to 60 PSI.

Jason

That is a very good point!! I went with the AEM 3.5 bar and did exactly what you said..!!
on a side note, do you run an ignition in your car and if so check out this thread please:

http://hondata.net/forum/viewtopic.php?t=7081