AC wiring with KPRO

bossman032 · Post by **bossman032** » Fri Sep 14, 2007 12:50 pm

I just got my ac kit installed on my dc2 Integra 95 GSR.

I was just wondering do I have to mess with anything on the K series ecu side? Any valid response would be appreciated. What I did was use the stock red wire for the clutch from the integra and ran it to k series compressor. the compressor goes on. but I am just wondering if anything else should be done on the k series side..

thanks
ronald :o

Post by **Spunkster** » Fri Sep 14, 2007 2:10 pm

Not knowing anything about the AC kit in question, this might be a better question for the company that makes the AC kit.

bossman032 · Post by **bossman032** » Fri Sep 14, 2007 2:58 pm

Spunkster wrote:Not knowing anything about the AC kit in question, this might be a better question for the company that makes the AC kit.

make sense but I thought I ask anyways. thanks for the reply. 8)