Rev bouncing up and down after WOT when idle

K-Series Programmable ECU installation questions / support issues
Locked
joejoe3
Posts: 17
Joined: Sun Aug 12, 2007 4:14 pm

Rev bouncing up and down after WOT when idle

Post by joejoe3 »

I have a question I would like to ask...
I'm currently supercharged at 11psi, and everytime when I go wide open throttle and then come to a full stop at idle, the rev will bounce up and down between 1000rpm to 2000rpm continously.

I can get it to go away by either driving it off or shutting the car off... does anybody know why it's doing this and how to fix it?
I tried the idle slider (to the left), the further left I go, the more it helps the situation (I think it acutally went away); however, the further left if goes, it also causes the idle to dip when coming to a stop under cruise or from WOT and stalls the car.
joejoe3
Posts: 17
Joined: Sun Aug 12, 2007 4:14 pm

Post by joejoe3 »

btw, i checked all bolts and nipples and there is no vaccum leak
User avatar
Spunkster
Site Admin
Posts: 23885
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

joejoe3
Posts: 17
Joined: Sun Aug 12, 2007 4:14 pm

Post by joejoe3 »

- serial number of your K-Pro: 00713
- the calibration (as an attachment)
- a datalog of a problem (as an attachment)
- what sort of vehicle you have: 2003 Acura RSX Type-S
- what sort of ECU you are using: K-pro, upgraded from stock ECU
- Injen Cold air intake, DC race header, tanabe exhaust, Hondata IMG, Jackson Racing Supercharger, AEM fuel rail, RC 750cc injectors, 3.0" (11psi) pulley.
You do not have the required permissions to view the files attached to this post.
User avatar
Hondata
Site Admin
Posts: 10616
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata »

http://www.hondata.net/forum/viewtopic.php?t=4044

Adjust your TPS so that it reads 0%. Flatten the cam angle tables just above idle and also reduce the ignition timing.

Remember that also a vacuum leak or stuck idle valve can cause this problem - and both are fairly common occurances.
Hondata
joejoe3
Posts: 17
Joined: Sun Aug 12, 2007 4:14 pm

Post by joejoe3 »

It's funny, because this only happens at idle after I put the car under WOT. If it's normal driving it wouldn't do this.

Also, I also got a question regarding to the idle.
At idle (set at 900rpm), the car will dip into 830-840rom for a quick second and you can feel the car hesitate for a bit and come back to 900rpm.

When i did a datalog, everything is fine... but as the rpm dips, ignition jumps up to 10... when it gets back to 900rpm, the ignition value goes varies back to 1-4
joejoe3
Posts: 17
Joined: Sun Aug 12, 2007 4:14 pm

Post by joejoe3 »

I found this in one of the reply's HONDATA gave in a misfiring thread at idle:
Welcome to Honda's ignition controlled idle speed. -2 to 10 degrees ignition timing is normal at idle - the main table is not used.
so that means it's normal for ignition to jump to 10 at random and rpm will dip 40rpms or so and hestitate?
Locked