engine stalls after rev

hondaflr · Post by **hondaflr** » Fri Aug 10, 2007 5:32 am

basically, running prelude calibration, rc750 injectors current injector size, 310 stock injector size , is set for parameters. h22 engine.

what is happening is i can drive and rev the engine no problem, but when i let off the gas, and the revs come down, the car just dies out. if i rev it up and allow it to drop slowly with the gas pedal i can keep it running.
we have checked for vacuum leaks, changed iacv, bleed coolant, adjusted idle screw and nothing. is there some settings i should be changing in the hondata to stop that from happening?

Post by **Spunkster** » Fri Aug 10, 2007 9:40 am

Have you adjusted the slider in the idle section of the software?

hondaflr · Post by **hondaflr** » Mon Aug 13, 2007 7:42 pm

i adjusted it all the way to the right, and intermitently it will drop. not all the time, but that did help.

is there any other settings i should be adjusting to get that running smooth.?

because its a pain to come to a stop in 2nd gear and bring it down to a 1000rpm then put the clutch in, so it wont stall.

Post by **Spunkster** » Tue Aug 14, 2007 10:16 am

Do you have a lightweight flywheel?

hondaflr · Post by **hondaflr** » Wed Aug 15, 2007 9:38 pm

i have the clutchmaster fx600 package

it comes with the twin plate setup and lightened flywheel

Post by **Spunkster** » Thu Aug 16, 2007 9:32 am

This is normal with a lightenend flywheel as there is less inertia to maintain the engine speed at low RPM.