Password for pocket programmer 2 software

EITCP · Post by **EITCP** » Tue Aug 14, 2007 5:27 am

recently my Laptop crashed and from now on i can not get my serial port pocket programmer 2 to work. On the hondata page i've found the 1.34 sofware for it (http://www.hondata.com/pocketprogrammer.html) but it is pasword protected. Where i can find the password for it?

Post by **Hondata** » Tue Aug 14, 2007 8:36 am

Download the software from the transtronic website at http://xtronics.com/memory/updates.html Check if you have a 2 or 2A programmer.

EITCP · Post by **EITCP** » Tue Aug 14, 2007 10:03 am

i did fix the problem.

i did called xtronics and download this software (no need of any password):

http://xtronics.com/memory/I-PP2Win2.41.exe

and install it. if you have any older version of this software you must delete/remove it!!!

then i did click (in a program for burning chips-win_ppl.exe)-on VPP-12V, press T and click on port delay and used higher numbers from 150 to 300. i find out that around 220 it works about 95% with success. So I hope this writing will help to other people with the same problem.

I did tryed to burn about 15 chips today (27C256, 27SF512, 29c256) and all were a success.