motorola 2.5 bar map sensor

alexsracing · Post by **alexsracing** » Wed Aug 08, 2007 9:55 am

I go to parameters > map > quick select > motorola 2.5bar

how do I get the table to show the new scale??
I see where to show 3 bar and 5 bar tables but no 2.5

Post by **Hondata** » Wed Aug 08, 2007 10:14 am

Select 3 bar and you will get 16 columns up to 28 lbs. The last column is not used with the 2.5 bar sensor (which reads to 22 lbs).

alexsracing · Post by **alexsracing** » Wed Aug 08, 2007 12:19 pm

Teamko · Post by **Teamko** » Thu Sep 13, 2007 5:43 am

following this same issue. I need a 3 or 4 bar map sensor and have a motorola also Hondata doesn't have settings for 3 or 4 or 5 bar motorola. I have the data sheet but don't see a direct corrolation to input into the scalar value and offset Hondata requires to make the map sensor work correct any assistance?

Post by **Hondata** » Thu Sep 13, 2007 8:09 am

Refer to the KManager help file on how to calculate the scalar and offset.

Post by **Hondata** » Fri Sep 14, 2007 8:18 am

Teamko: First & final warning: Stop commercial spam or be banned.