Problem with Datalogging

Joelspy70 · Post by **Joelspy70** » Thu Jul 26, 2007 11:59 am

I was trying to do a datalog yesterday but half way through the datalog it kept loosing the usb connection and would stop. I tired a different laptop, and a different usb cable with the same problem. It has worked fine before. I am woundering if this is an issue with the port on the ecu? Can hondata fix this if it is?

Post by **Spunkster** » Thu Jul 26, 2007 12:31 pm

What spark plugs are you using? What vehicle is this in? What version of software are you using from Help, About?

Joelspy70 · Post by **Joelspy70** » Thu Jul 26, 2007 8:12 pm

Car: 03 Rsx type S k20a2
Spark Plugs: NGK-BKR7EIX
K Manager Version: 1.2.2.6

Post by **Spunkster** » Fri Jul 27, 2007 9:29 am

What has been done to the vehicle?

Joelspy70 · Post by **Joelspy70** » Fri Jul 27, 2007 10:41 am

Spunkster wrote:What has been done to the vehicle?

Greddy turbo kit and FMIC at 10 psi
Test pipe
3" cat back
Just installed new motor mounts

Post by **Spunkster** » Fri Jul 27, 2007 12:22 pm

Have you properly relocated the ground? Are all the grounds still in the proper location and corrosion free?
http://www.hondata.com/techk20ground.html

Post by **Hondata** » Sat Jul 28, 2007 11:47 am

Also check the wiring where is passes behind the turbo. The heat from the turbo hardens the copper in the wiring and it eventually fractures.

Joelspy70 · Post by **Joelspy70** » Sat Jul 28, 2007 4:49 pm

Spunkster wrote:Have you properly relocated the ground? Are all the grounds still in the proper location and corrosion free?
http://www.hondata.com/techk20ground.html

My engine ground is still on the intake manifold. I will try moving it to the valve cover.