bad jumper haarness

turbo-2nr · Post by **turbo-2nr** » Mon Jul 23, 2007 8:27 am

wondering if any one has a diagram on what wires go were on a obd2a to obd1 jumper harness(ecu) so i can check and see if this is my problem. Thanks.

scttydb411 · Post by **scttydb411** » Mon Jul 23, 2007 8:31 pm

what brand harness? what is your issue?

i've seen 2 brands (they look identical) that have more problems than not. i always recommend boomslang. i have never had a car come through my dyno that has a problem w/ a boomslang. the other 2 unmentioned brands have a very high failure rate and i recommend against them to my customers because of this.

turbo-2nr · Post by **turbo-2nr** » Tue Jul 24, 2007 8:41 am

it was one from rywire. i fixed the prob a6 and a4 were switched the previous owner had a vafc on it and i guess was care less when he took it off the car. last night i switched them and it runs perfect. but i planned pick n up a boomslang still every one i know that has one has no problems