wiring up meth injection

my friend · Post by **my friend** » Wed Jul 18, 2007 10:06 am

hello i have recently installed snow performance stage one and i have a question about what pin to use for nitrous control... i have one wire coming off the relay and it need 12 volt with key on... please help

Post by **Spunkster** » Wed Jul 18, 2007 10:28 am

There should be a switched 12 volt power source on the fuse box under the dash.

my friend · Post by **my friend** » Wed Jul 18, 2007 11:19 am

Spunkster wrote:There should be a switched 12 volt power source on the fuse box under the dash.

and after that how and what do i wire to use nitrous control?

Post by **Spunkster** » Wed Jul 18, 2007 2:50 pm

http://www.hondata.com/techkpronitrousdiagram.html

my friend · Post by **my friend** » Wed Jul 18, 2007 8:25 pm

Spunkster wrote:http://www.hondata.com/techkpronitrousdiagram.html

so all i do is run/splice that wire for 12v to e21 and then just cut wire going to e22?
if so thnx im gonna try it tom and report back thnx alot man :D