TPS Problems

K-Series Programmable ECU installation questions / support issues
Locked
Anointeddc5
Posts: 32
Joined: Tue Mar 27, 2007 2:34 pm
Location: Lincoln, NE

TPS Problems

Post by Anointeddc5 »

I am having issues with my TPS. At idle it reads 0% but at WOT it only reads 98% what do I need to do to fix this?
User avatar
Hondata
Site Admin
Posts: 10616
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata »

First, the car will run fine if the TPS reads 98% at full throttle. It only needs to be over about 60%.

Second, you can adjust the TPS. Parameters->TPS->Scale TPS.
Hondata
Anointeddc5
Posts: 32
Joined: Tue Mar 27, 2007 2:34 pm
Location: Lincoln, NE

Post by Anointeddc5 »

Thanks I got everything all figured out. My next question is how do you know if an injector or coil has gone bad? Will KPRO display the misfire code? Also what are symptoms of a fried ECU?
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

Are you having a problem? It's much easier to troubleshoot symptoms than to try to associate symptoms to a problem.
Anointeddc5
Posts: 32
Joined: Tue Mar 27, 2007 2:34 pm
Location: Lincoln, NE

Post by Anointeddc5 »

Well here is the thread I originally posted up http://www.hondata.net/forum/viewtopic.php?t=6150

The car just sputters (loses power) and stays at 6k rpm for about 5-10 secs then shoots past it but gets cut off completely at 7500 rpm. I have a tuner working on my a/f but even with all the changes we make the problem persists in the exact same spots, so I am wondering if it is a mechanical/electrical issue rather than a tuning issue although I know the calibration can be cleaned up quite a bit. I checked the wire harness and all seems fine except for the vtec solenoid looks a little on the melted side would that cause the problem?
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

Anointeddc5
Posts: 32
Joined: Tue Mar 27, 2007 2:34 pm
Location: Lincoln, NE

Post by Anointeddc5 »

Well the link I provided had the information you guys requested thats why I posted it up.

Engine setup:
RSX Type-S
k20a2
Greddy Turbo kit w/intercooler
IPS KT1 Cams
Eibach EVS with Ti Retainers
RC 750cc injectors
Walbro 255 Fuel Pump
Stock returnless fuel system
NGK Bkr8iex Plugs
Hondata KPRO ECU
Ground Cables
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

That was posted 4 months ago and you said you have had a tuner making changes to it.
Locked