check out my datalogs please

montrealcityboy0069 · Post by **montrealcityboy0069** » Sun Jul 01, 2007 9:23 pm

i have a k20a3,aem v2 intake,dc-sport shorty header,t1r test pipe,dc-sports cat-back exhaust
i'm putting 94 octane gas,and the calibration i use is the civic tuned high octane

the first one was in 3rd gear WOT on the highway,unfortunately i couldn't go to my rev limit of 7300 rpm because there was traffic and had to stop at 6900 rpm but this should give you an idea,now kthreshold is set at 0.00v and where the knock occurs my klevel didn't really go behond 1.00v

second run i did was in 2nd gear WOT,again i couldn't go to the rev limit because of too many cars... again check my ktreshold and klevel

any good comments,opinions and suggestions will be very appreciated,thanks!

petah · Post by **petah** » Mon Jul 02, 2007 8:37 am

i'd suggest you try a few more datalogs... you didn't really do WOT on both datalogs...