QUESTION ON "INJ"

babybenz · Post by **babybenz** » Wed Jun 27, 2007 6:35 pm

All,
When car is idling and I throttle it to say >3000rpm, I notice that sometimes, the "INJ" in my S300 "DISPLAY" sometimes shows "0" in green then back to some readings again. Is this normal?

I am driving an EG6.

Post by **Spunkster** » Thu Jun 28, 2007 9:23 am

Are you having a problem?

Post by **Hondata** » Thu Jun 28, 2007 10:29 am

Sounds liks fuel overrun cutoff.

babybenz · Post by **babybenz** » Thu Jun 28, 2007 7:18 pm

Spunkster wrote:Are you having a problem?

SS,
Yes, I am having a problem and that is engine stalling problem.

I notice that when the "INJ = 0" happens at a lower rpm when I rev to 3-4k rpm, the rpm will drop to very slow and many times stalls.

When the "INJ = 0" happens at a higher rpm, then rpm drops but does not go below 1k rpm (this is the set idle rpm).

Sometimes, the "INJ = 0" never shows at all.

Post by **Spunkster** » Fri Jun 29, 2007 9:20 am

Please post datalogs and the calibration that shows the problem.

deafy · Post by **deafy** » Fri Jun 29, 2007 12:48 pm

I think injectors dont spray at all if you let off the gas completely and rpm's drop till idle speed and it starts spraying. Hence the INJ=0