Any way to easily scan datalog for a code?

ITR 1102 · Post by **ITR 1102** » Fri Jun 15, 2007 8:35 pm

I need to know if I am throwing a code as the motor is cutting out on me.
I posted a thread in the tech non ecu forum.

Browsing through the datalog, I am not seeing anything, but my ECU light is only on as long as the power is out. The power comes back on as soon as I get off and then back on the gas, so finding those two spots on the recording is very difficult.

Is there any way to tell if a datalog has any ecu codes at any point in the recording?

Post by **Spunkster** » Mon Jun 18, 2007 3:22 pm

scroll throught the datalog and look at the error codes box to see if any show up.

ITR 1102 · Post by **ITR 1102** » Tue Jun 19, 2007 3:31 pm

Spunkster wrote:scroll throught the datalog and look at the error codes box to see if any show up.

I knew about this way, I was curious if there is any way to be able to easily tell when opening a file if there are error codes?
Could something like this be created easily?

The reason I ask is because I am looking for a needle in a hay stack in my recording and have no idea where it is at...