datalogging afr instead of lambda

jew · Post by **jew** » Mon May 28, 2007 10:05 pm

is there a way to have the datalog display afr instead of lambda? i know its probably something obvious but i can't find the option. i also can't find the option to display afr instead of lambda in the sensor display window.

PianoMan · Post by **PianoMan** » Tue May 29, 2007 7:07 am

Under Options -> Settings -> Wideband Lambda Tab: Choose "Air Fuel Ratio" for Lambda Unit.

Then click the "Display" Tab and check "Lambda". That should get you the display.

I haven't tried it yet, though... I'm due to install my SM-AFR WB this week. Should work, though!

PM

jew · Post by **jew** » Tue May 29, 2007 9:08 am

i tried that already. the only thing that seems to change is on that same tab where you set voltage = afr. it still displays lambda when datalogging and on the lambda sensor display. i would figure the setting would be under units in the options, but its not there either.

GTMcoupe · Post by **GTMcoupe** » Tue May 29, 2007 9:59 am

This will sort it as this option configures the display/sensors

Under Options -> Sensors, then select AF

then in the option choose air fuel ratio and set the high low limits as needed

WEST

jew · Post by **jew** » Tue May 29, 2007 10:26 am

thanks, i'll try that when i get off work in a couple hours. hope it works!

PianoMan · Post by **PianoMan** » Fri Jun 01, 2007 8:54 am

Ah. Forgot about that as well.

I've set that up now, too! Thanks!

...just gotta find the time to get this PLX wideband in...

PM