Fuel Table help

delsolb20 · Post by **delsolb20** » Tue May 29, 2007 3:00 pm

I need to learn how to set my fuel table but i don?t know how, I tried by selecting the columns and the rev columns and press the plus key (+) and I didn?t see anything change and I have a 440RC injectors

Thanks

Preccord00 · Post by **Preccord00** » Tue May 29, 2007 4:19 pm

goto the fuel table, select which RPM-MAP block you want to adjust, right click and select adjust or CTRL+J. Then adjust as necessary, if you need to adjust multiple blocks at once, highlight them by clicking and dragging over the blocks you wish to adjust.

I highly suggest the use of an AFR to fine-tune your fuel-map, otherwise you're taking shots in the dark and engine damage may occur.

delsolb20 · Post by **delsolb20** » Tue May 29, 2007 7:26 pm

Thanks!

I am using the ITB calibration for my b20/v-tec the thing is that is to rich on low rpm and in the high rpm lean that?s why I need to learn to use the tables