diff air temp compensation after save

revrpm · Post by **revrpm** » Thu May 17, 2007 9:39 am

Hi,

I had been using the Kpro in my car for years. And recently i had update my software to 1.2.2.4. Right now i face a problem. Whenever i save a rom file and open up again. It was prompt me that the rom file is having different high and low air temp compansation. Could anyone from here experience this problem? Or would anyone be able to advice me whether i have problem with my software when i update it.

Cheers,

Post by **Hondata** » Thu May 17, 2007 10:19 am

Can you post your calibration?

revrpm · Post by **revrpm** » Fri May 18, 2007 7:20 pm

Hi Hondata,

The calibration is stock. The air temp compensation map is -30, -0, 30, 80 98 respectively after i save the map. The correctio figures are still the same.

Then when i attemp to change the figures on the IAT, it seem not happy with that and remain the same.

Hope to hear from you soon.

Cheers,

Post by **Spunkster** » Mon May 21, 2007 9:21 am

Hondata wrote:Can you post your calibration?

revrpm · Post by **revrpm** » Mon May 21, 2007 7:40 pm

Hi Spunkster,

Please look thru the attach map which i had save.

Post by **Hondata** » Tue May 22, 2007 9:25 am

Switch your unit settings to fahrenheit, open the calibration, switch to celcius, save the calibration.

revrpm · Post by **revrpm** » Fri May 25, 2007 8:39 pm

Hi there,

Finally it works!!! Thanks for everything ...

Cheers,

Garrett_si · Post by **Garrett_si** » Sun May 27, 2007 8:25 am

revrpm wrote:Hi there,

Finally it works!!! Thanks for everything ...

Cheers,

take a look on your cam maps

a lot of work have to be done on yours