Datalogging graph setup

rjmcalister · Post by **rjmcalister** » Sun Apr 08, 2007 5:35 am

Is it possible to view the cursors x,y coordinates using the S300 datalog graph?

Post by **Spunkster** » Mon Apr 09, 2007 9:59 am

Can you be a little more specific?

rjmcalister · Post by **rjmcalister** » Mon Apr 09, 2007 3:41 pm

While viewing a datalogged graph is it possible to view the cursors X,Y coodinates as you drag it across the graph? I guess the main thing is can the Y axis be scaled, for example the MAP sensor graph shows the range being 0-3 Bar. I would like to be able to place the cursor at 7500 rpm, somewhere above the x axis and be able to see what reading the MAP sensor is showing. Currently I have guess where I am between 0 and 3 Bar.
Thanks

Post by **Spunkster** » Tue Apr 10, 2007 9:08 am

While draging the line across the graph just look at the sensor list or the display and you can see exactly what the sensors are reading at any point on the graph.

rjmcalister · Post by **rjmcalister** » Tue Apr 10, 2007 4:36 pm

just what I was looking for, thanks

Hondata

Datalogging graph setup

Datalogging graph setup

X<Y graphing

Datalogging graph