USDM on JDM

Javcolin · Post by **Javcolin** » Tue Apr 03, 2007 11:52 pm

Is it posible to use a USDM ECU on A JDM car?? cause i got the US ECU instead of the Square one for JDM will it work??? Thanks

Post by **Spunkster** » Wed Apr 04, 2007 9:47 am

They are interchangeable, just make sure you get the correct s300 for the ecu you have.

Javcolin · Post by **Javcolin** » Mon Apr 09, 2007 9:22 pm

Thats good. now what calibration should i use. Stock JDM P30 or Stock USDM P30. since the engine is JDM or it doesn?t matter wich one to use?? thanks for all your help

Post by **Spunkster** » Tue Apr 10, 2007 10:02 am

It is completely up to you what calibration you start with. You just need to make sure you disable the sensors that your ecu does not have.

Javcolin · Post by **Javcolin** » Mon Apr 16, 2007 1:58 am

Thanks for your help, now how do i know which sensors are the ones my ECU doesn?t have??

Thanks again

Post by **Spunkster** » Mon Apr 16, 2007 11:27 am

You will get errors immediately if it does not have the sensors. Usually, ELD, BARO, Fuel Injector Error...etc.

Javcolin · Post by **Javcolin** » Wed Apr 18, 2007 8:44 pm

Thank you very much. you have been very helpfull.

Javier