EGR and ELD questions

crxrocks · Post by **crxrocks** » Mon Feb 19, 2007 1:29 pm

I have a S300 installed in a P06 ECU. If I decide to use the ELD input for my PLX wideband do I have to anything physically to the ELD to disable it or is all that is needed is to disable it in SManager.

Secondly, I am considering using the EGRL input for the WB instead of the ELD since my CRX w/ DOHC ZC doesn't have a EGR. Does the P06 contain all of the necessary "guts" to support use of the EGRL input in this manner?

Thanks!

Chris

Post by **Spunkster** » Mon Feb 19, 2007 2:48 pm

You need to remove the wire that goes to the eld and then in the calibration disable the eld error.

crxrocks · Post by **crxrocks** » Mon Feb 19, 2007 5:19 pm

Thanks. Do you know of the P06 contains all the hardware required for EGR if I want to use that input instead?

Post by **Spunkster** » Tue Feb 20, 2007 10:22 am

All ecu's should have the input circuitry.