GM Map Sensor Calibrations

civicgsr2000 · Post by **civicgsr2000** » Wed Feb 14, 2007 9:42 am

Ok... I have a GM map sensor installed, using the motec calibrations, but on the display showing map, it shows 4-5psi at idle, that doesn't seem right because my boost guage shows vacum. I got a t3/t4 setup, and I know boost shouldn't be showing up. do I have a calibration issue?

Post by **Spunkster** » Wed Feb 14, 2007 10:44 am

Sounds like you have wired the sensor incorrectly, or have the wrong sensor. We do not recommend the GM sensor as there are at least 3 different versions. Once a map sensor has been wired incorrectly it is damaged.

civicgsr2000 · Post by **civicgsr2000** » Wed Feb 14, 2007 11:32 am

what sensor do you rec, or even do you have a precise part number for the correct sensor?

Post by **Hondata** » Wed Feb 14, 2007 11:42 am

The sensor we sell, which is a Motec part.

civicgsr2000 · Post by **civicgsr2000** » Wed Feb 14, 2007 11:47 am

how much and shipping to 33409.

civicgsr2000 · Post by **civicgsr2000** » Wed Feb 14, 2007 12:26 pm

I have a part number 1222381, I do recall mis wiring so I know now that the sensor is dead, but not completely because I was able to at least drive around. How many people do actually use these gm sensor, how many have complications, and how many do not. should I try using a working map sensor, the dealership is right down the street. will the motec map have the same connector as the gm map?

Hondata

GM Map Sensor Calibrations

GM Map Sensor Calibrations

gm map sensor

hondata map sensor

gm sensor