My s200 .bin file to my s300 .skl file?

raysjdmh22a4 · Post by **raysjdmh22a4** » Sun Dec 17, 2006 9:59 pm

hey whats up guys. I have a small problem I got the s300 awhile back and I had an s200 before I have my old s200 .bin file save I go to open it in the s300 a boxs pops up and tell's me about my injectors are old 240cc to 430cc and about the colums has to be 20 instead of 24? but on previes tune my injectors are 880cc and I dont know why in the s300 it say's 430cc.. is there any way some one can help me and open my bin file and write down my this info please.. so I can save it on my s300 an upload back up so i can drive my car.. thanks in advances

stock injectors:
current injectors:
over all fuel trim:
cranking fuel trim:
throttle fuel trim:
post start fuel adjustment:

Ray

Post by **Spunkster** » Mon Dec 18, 2006 11:25 am

Whoever tuned your car previously probably made tha changes to your injector multiplier incorrectly. Just say ok, load the file into your ecu and try it. It should run properly.

raysjdmh22a4 · Post by **raysjdmh22a4** » Mon Dec 18, 2006 1:26 pm

but wont it run lean? since I have the 880cc and not 430?

Post by **Spunkster** » Mon Dec 18, 2006 1:38 pm

Just try it...if it runs badly then you go from there