Any chance Hondata will have more RPM and load points??

TurboLS · Post by **TurboLS** » Sun Dec 03, 2006 6:06 pm

Basically, I am designing a custom valvetrain and I need to have more quantization points for fuel and ignition values across the map. I know I can do this in load by using the boost tables and changing the values, but that's kind of using them for a different purpose, and only solves half the problem. If you could shed any light on this, that would be awesome.

Post by **Spunkster** » Mon Dec 04, 2006 10:56 am

If this is an LS, then set up VTEC and use the high and low cam tables.

TurboLS · Post by **TurboLS** » Mon Dec 04, 2006 11:24 am

and i guess i would just wire a signal to the VTP switch when i want the maps to switch, correct?? Are there any other considerations I should be aware of???

Jaker · Post by **Jaker** » Mon Dec 04, 2006 1:29 pm

Just disable the VTP error code, and set the Vtec point where you want the maps to switch. The ECU will never know the difference.

TurboLS · Post by **TurboLS** » Mon Dec 04, 2006 3:21 pm

and by VTEC point, you mean RPM, correct?? thanks for the help.

Jaker · Post by **Jaker** » Thu Dec 07, 2006 5:16 pm

Yes, RPM.

QUICKSILVER RACING · Post by **QUICKSILVER RACING** » Sun Dec 10, 2006 8:35 pm

you can also add more load points by activating the secondary tables.

10 more columns for your tuning pleasure.