S300 Boost Control

JITU · Post by **JITU** » Fri Nov 24, 2006 11:30 pm

I am running JDM B16A 2nd gen Engine with JDM OBD1 P30 ECM, I am planning to go for Hondata S300J for Boost, with a new feature of Boost control from the ecu which can be used only on USDM ECU since JDM ECU does not have circuitry to modify for boost control, can i use a USDM P28 ECU with Hondata S300 & Boost control option to run on an JDM Engine? will it work ? I want to compare P28 US & P30 JDM Codes for refrence.
any clues ? I want to use boost by gear feature on S300 with boost control.

Thanks in advance
Jitu

QUICKSILVER RACING · Post by **QUICKSILVER RACING** » Sat Nov 25, 2006 9:18 am

should be no problem.

just load your tuned calibration to your new ECU.

Post by **Hondata** » Sat Nov 25, 2006 11:55 am

If you load the calibration into a US or JDM ECUs they will run the same. We have noticed a slight difference in the idle control circuitry, but the fuel, ignition etc will be the same.