Hey Guys, Need help in adjusting Nitrous w/ K-Pro

Craig_Ellis · Post by **Craig_Ellis** » Sun Sep 24, 2006 6:04 am

Well, I have everything hooked up now to K-Pro. (had the dealer hook up my wires to the ECU).

I am using a 50 shot and the default nitrous fields when selecting "enable nitrous". I am using a base map (stock engine w/ 440cc injectors) with the K-Pro.
The map was adding 200 fuel units and retard'ing the engine 4 degrees. (i dont know if this is good or not). I went to use the car with the nitrous and the engine started to backfire, and ran like crap. It was starting to run so bad, that I got out and took the fuse out of my nitrous relay and re-uploaded the base map without the nitrous enabled.

Thanks guys,
Craig

Post by **Spunkster** » Mon Sep 25, 2006 9:30 am

You need to tune this properly on the dyno to avoid damaging your engine.