Where do I get pins to add contact points to ECU harness?

TurboLS · Post by **TurboLS** » Fri Sep 22, 2006 6:52 am

basically, I have a P75 ECU and I want to use D6 VTP as a clutch switch input. However, there is no pin to solder to in the harness. Does anyone know where I can get some of these so I don't have to wire directly to the ECU trace or just jam the wire into place?? thanks.

Post by **Spunkster** » Fri Sep 22, 2006 9:21 am

best bet is depining some wires at the junk yard

TurboLS · Post by **TurboLS** » Fri Sep 22, 2006 9:51 am

alright, i'll give that a shot.