s300 with aem 5 bar map sensor

Post by **Hondata** » Wed Sep 13, 2006 8:44 am

Just use the default '5 Bar' setting. Switch the key on and check the MAP reading. It it is not atmospheric pressure, then check you wiring and/or MAP sensor. If you mis-wire a MAP sensor once, even briefly, it usually dies.

Silverbeast · Post by **Silverbeast** » Wed Sep 13, 2006 10:29 am

5 bars work fine as with the S300 :)

Use the settings that he said and it wll work.

BabyBhp · Post by **BabyBhp** » Wed Sep 13, 2006 2:36 pm

What would be the correct way to wire this in?

WickedCivicNY · Post by **WickedCivicNY** » Thu Sep 14, 2006 10:30 am

wire it like you would a GM 3 Bar .. Signal/Power/ground