Adding knock control for B and D series to Hondata

[Motorvations EDM]

Hello,

@ Hondata pro's, I have a quick question.
What do you think about adding knock control to the Hondata software?
Where are the difficulties?
Let's assume I am able to place a knock sensor between cylinder 1 and 2 and one sensor between 2 and 3 (for open deck design) and would get exact readings of the sleeve oscillation, what would you need or would it be possible to interpret the signal in Hondata? (sorry for my bad English).
I mean, like the stock knock board but just "enhanced" to read until red line and to read from several knock sensors.
Wouldn't that be interesting for all of us or do you think the potential effort in terms of software modification is not worth it?

Thanks for your time,

Andreas

[Hondata]

The ECU main processor does not have control over the stock knock board and so we can not change its behaviour.