Downloaded new cal file and car will not run

SinistiR · Post by **SinistiR** » Fri Jul 14, 2006 12:54 pm

OK, so I am trying to tune a EK chassis civic right now with a K20a motor in it . I am using the latest version of K-Pro and when I downloaded a K20a cal file onto the ECU the car will not run. It will not run now with the original cal file either. The original cal file was an older version than the version of K-Pro I am running now. The car will act like it wants to start, but as soon as it does, it shuts right down. The only thing that looks out of place when I monitor the gauges is that the ignition timing does not move from 0, but when I watch the ignition map while cranking the car it move through the proper load ranges. Any ideas on what is going on here?

SinistiR · Post by **SinistiR** » Fri Jul 14, 2006 1:12 pm

fixed it, the multiplexer was still enabled.