Options for 3 bar MAP sensor

abp-rsx-s · Post by **abp-rsx-s** » Mon Jun 26, 2006 8:53 pm

Hi, I was wondering what's a good 3 bar MAP sensor to get? I heard the GM's aren't that great but yet almost everyone on clubrsx is using them lol. I was looking at the AEM one. thx

Post by **Spunkster** » Tue Jun 27, 2006 9:56 am

Hondata recommends the Motec 3-bar map sensor. This can be purchased through any Hondata dealer for $90.

boredfast · Post by **boredfast** » Sun Jul 02, 2006 8:24 pm

does that come w/ the pigtail for 90?

in any case, i was looking thru the revised version and noticed "MSD 3 BAR"..... I know the guys using the MSD purchased thru summit were using neetronics 3.0 (as that was the closest).. so this would be spot on?

I have no clue whether or not this is actually a MSD 3 bar, when I purchased it, it looks exactly like a GM, with white-out on there, and even something "scratched out." i'm assuming these are recycled or some shit.. any input?

Post by **Spunkster** » Wed Jul 05, 2006 11:54 am

The motec sensors come with a pigtail.

boredfast · Post by **boredfast** » Fri Jul 07, 2006 7:34 pm

thanks, but in reference to the MSD setting, this would be spot on?

in any regards, if this is NOT accurate, I will go ahead and order a motec sensor in the near future..

Post by **Spunkster** » Tue Jul 11, 2006 9:42 am

There is a setting for the MSD, but I highly recommend getting the Motec.

abp-rsx-s · Post by **abp-rsx-s** » Wed Aug 16, 2006 2:14 pm

how about the Zeitronix 3.5 MAP sensor, I've heard it's just like the aem 3.5 map sensor but it costs a lot less lol. Does Hondata recommend that one? http://www.zeitronix.com/order/order.htm , the 4th item down
thx

Post by **Spunkster** » Wed Aug 16, 2006 3:22 pm

Spunkster wrote:I highly recommend getting the Motec.