are these non-resistor plugs?

Hogie · Post by **Hogie** » Tue Jun 27, 2006 11:48 pm

im running a cyberntion kit wit the 60-1 turbo with 1000cc injectors and hoping to turn the boost up, but every time i dialog, like previous other members the kmanager cuts out, it just stops dialogging and it says the ignition is off and everything loses connection, so i ahve to turn the car off and unplugg and replugg the usb, but this cut onlyh happens when i get on it into high rpms in second and higher gears.

im running the ngk BKR7E 6097

if these are not the right plugs i should go with, can someone recommend me to the plugs i should use (please include brand and part number)

Post by **Spunkster** » Wed Jun 28, 2006 9:52 am

Do you have a resistor box installed for the injectors?

Hogie · Post by **Hogie** » Wed Jun 28, 2006 10:32 am

im using "injector drivers"

Hogie · Post by **Hogie** » Fri Jun 30, 2006 11:15 am

so will these plugs do??
is there anything else i need to be aware of?
of yah bout much much fuel pressure should i put at the injectors?

50-60 psi??

Post by **Spunkster** » Fri Jun 30, 2006 1:15 pm

The problem is the aftermarket injector drivers. You will need to remove that and install a resistor pack to run the low impedance injectors.